Ripper v2 SuppBar Mod (630W) - Three week pre-order

Ripper v2 SuppBar Mod (630W) - Three week pre-order

Regular price R 17,000.00

This is an example Ripper mod for a customer with a 2.4 x 1.2m tent.  Making use of some of our new supplemental wavelength PCBs.  

At the recommended 90% driver load, this light is 630W total.  

The LEDs are spaced out a bit more than the standard Ripper distances, so the light would need to run fairly close, (around 20cm) from the canopy for higher PPFD levels.  More typical distances (30cm+) are giving roughly 500 PPFD measurements.

630W is often used for a smaller space (see the Chinese lights section) - typically 1.5 x 1.5m, which is 78% the area of a 1.2 x 2.4m tent.  So it's not maxing out the area.  But it's a good basic wattage for the area, to get usable flowering levels throughout the tent.


Consists of an immense:

1728 x Samsung LM301B LEDs,
and (44 x Osram Square/SSL monochromatic LEDs) for some extra blue/red/far-red.

Driven on a 96% efficient Mean Well HLG-600H driver,
and 93% efficient Delta LNE-48V100WAA driver.  Both are dimmable.

Light is two pieces, square meter size each.  Four ratchet pairs.

Should be good for full cycle growth, veg to harvest.  We haven't tested lights with far red in veg yet, but the red to far red ratio is such that it shouldn't be an issue.
 

The efficiency is approximately 2.7uMol/J.  (194lm/W pre driver, 186lm/W post driver)

Let us know if there is a better deal in SA.